Filter
Top Products
L
R
L
R
L
R
LINE
OUT
A
B
BRIDGEDBRIDGED
INPUT
SENSITIVITY(V)
CONTROL
OPERATION
B
CONTROL
A
(Lch)
MONO
MAXMIN
0.3
0.5
1.0
STEREO
INPUT
SENSITIVITY(V)
MAXMIN
0.3
0.5
1.0
INPUT SELECTOR
AA B
LPF
OFF
FILTER
HPF
OPERATION
MONO(Lch)STEREO
LPF
OFF
FILTER
HPF
L
R
L
L
R
L
R
L
R
L
R
L
R
LINE
OUT
A
B
C
L
C
INPUT
SENSITIVITY(V)
CONTROL
OPERATION
B
CONTROL
A
(Lch)
MONO
MAXMIN
0.3
0.5
1.0
STEREO
INPUT
SENSITIVITY(V)
MAXMIN
0.3
0.5
1.0
INPUT SELECTOR
AA B
LPF
OFF
FILTER
HPF
OPERATION
MONO(Lch)STEREO
LPF
OFF
FILTER
HPF
6
System examples
■
Tri-mode
CENTER UNIT
(High pass)
Subwoofer
(L + R) (Bridged)
■
High-power 2-channel system
CENTER UNIT
Left
speaker
Right
speaker
●
Principle of Tri-mode
Method of frequency band division using a coil and capacitor•••in case of 6dB/oct. slope
L
C
0 dB
-3 dB
Coil (L):
Passes low frequencies and blocks high
frequencies. (Low pass)
Capacitor (C):
Passes high frequencies and blocks low
frequencies. (High pass)
Crossover Frequency
Frequency
159000
C= (µF)
fc x R
159 x R
L= (mH)
fc
fc=Cut of Frequency (Hz)
R=Speaker Impedance (Ω)
●
Example:
When it is required to set a crossover frequency of 120 Hz using speakers with an
impedance of 4 ohms.
Prepare commercially-available coil and capacitor with the closest ratings to the results
calculated from the formula above. The capacitor rating should be as close as possible to 331.25
(µF) and the coil rating should be as close as possible to 5.3 (mH).
• If you wish to bridge-connect a speaker, the speaker impedance must be no less than 4 ohms.
Connecting a speaker with an impedance lower than 4 ohms may damage the unit.
• Be sure to connect capacitors to speakers to which high frequencies will be passed. Failure to
do so will result in a drop of the combined impedance with the subwoofer.
• Ensure that the withstand voltage and current ratings of the capacitors (C) and coils (L) are
sufficient.
2CAUTION
L
R
L
R
L
R
L
R
LINE
OUT
A
B
BRIDGED
INPUT
SENSITIVITY(V)
CONTROL
OPERATION
B
CONTROL
A
(Lch)
MONO
MAXMIN
0.3
0.5
1.0
STEREO
INPUT
SENSITIVITY(V)
MAXMIN
0.3
0.5
1.0
INPUT SELECTOR
AA B
LPF
OFF
FILTER
HPF
OPERATION
MONO(Lch)STEREO
LPF
OFF
FILTER
HPF
■
High-pass + Subwoofer system
CENTER UNIT
(High pass)
Subwoofer
(L + R)
(Bridged)
Switch setting
Switch setting
Switch setting