Kenwood KAC-PS401M Car Amplifier User Manual


 
English
13
Specifications
Specifications subject to change without notice.
Audio Section
Max Power Output (2 ) ....................................................................................................1200 W × 1
Rated Power Output (+B = 12.0 V)
(4 ) ..................................................................................200 W × 1 (20 Hz ~ 20 kHz, 0.05 % THD)
(2 ) ....................................................................................................400 W × 1 (1 kHz, 0.5 % THD)
Rated Power Output (+B = 14.4 V)
(4 ) ........................................................................................300 W × 1 (DIN : 45324 , +B = 14.4V)
(2 ) ....................................................................................................600 W × 1 (1 kHz, 0.5 % THD)
Frequency Response (+ 0 , – 3 dB) ................................................................................5 Hz ~ 50 kHz
Total Harmonic Distortion (Rated power)
#
....................................................................0.002 % (1 kHz)
Sensitivity (rated output) (MAX.) ..................................................................................................0.2 V
Sensitivity (rated output) (MIN.) ....................................................................................................5.0 V
Signal to Noise Ratio ..................................................................................................................105 dB
Input Impedance ..........................................................................................................................10 k
Damping Factor ....................................................................................More than 9900 (at connect)
Low Pass Filter Frequency (24 dB/oct.) ..............................................................50 ~ 200 Hz (variable)
Infrasonic Filter Frequency (24 dB/oct.) ..................................................................15 / 20 / 25 / 30 Hz
Band Reject Filter Frequency..............................................................................40 ~ 200 Hz (variable)
# Sensitivity = Mini. , Through LPF (30 kHz)
General
Operating Voltage ....................................................................................12.0 V (11 ~ 16 V allowable)
Current Consumption (4 , +B = 12.0 V, 10 % THD) ....................................................................36 A
Dimensions (W × H × D) ........................................................................................272 × 64 × 380 mm
Weight..........................................................................................................................................7.0 kg
Troubleshooting Guide
PROBLEM POSSIBLE CAUSE SOLUTION
If the slide panel moves of
its own accord.
The external amplifier
controller (B.M.S.) will not
work.
The system is in DEMO mode.
The slide panel has gone into
remote operation mode.
The B.M.S. switch is set to
"B.M.S. (+6)".
The external amplifier control
cable has come loose.
Cancel DEMO mode by pressing
the OPEN/CLOSE button.
Check the B.M.S. and operate
the slide panel remotely or
manually.
The B.M.S. switch is set to
"(REMOTE)".
Check that the external amplifier
control cable is properly
connected.