Filter
Top Products
10
1
Press the volume knob to enter [FUNCTION] mode.
2
Turn the volume knob to select [AUDIO CTRL] or [SETTINGS], then press to enter.
3
Turn the volume knob to make a selection, then press to confirm.
See table below for selection.
Repeat step 3 until the desired item is selected/activated.
Press to return to the previous item.
4
Hold to finish the procedure.
[AUDIO CTRL] : While listening to any source except in STANDBY state...
Item Selectable setting (Preset: *)
SUB-W LEVEL –15 — +15 (Preset: 0): Adjusts the subwoofer output level.
BASS BOOST B.BOOST LV1 */ B.BOOST LV2: Selects your preferred bass boost level. ; OFF:
Cancels.
SYSTEM Q NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ GAME: Selects a preset sound mode suitable to the
music genre. (Selects [USER] to use the customized bass, middle, and treble settings.)
BASS ADJUST BASS C FRQ: 60/ 80/ 100 */ 200:
Selects the center frequency.
BASS LEVEL: –8 — +8 (Preset: 0):
Adjusts the level.
BASS Q FCTR: 1.00 */ 1.25/ 1.50/ 2.00:
Adjusts the Q factor.
BASS EXTEND: ON: Turns on the extended bass. ; OFF *:
Cancels.
MID ADJUST MID C FRQ: 0.5K/ 1.0K */ 1.5K/ 2.5K:
Selects the center frequency.
MID LEVEL: –8 — +8 (Preset: 0):
Adjusts the level.
MID Q FCTR: 0.75/ 1.00 */ 1.25:
Adjusts the Q factor.
TRE ADJUST TRE C FRQ: 10.0K/ 12.5K */ 15.0K/ 17.5K:
Selects the center frequency.
TRE LEVEL: –8 — +8 (Preset: 0):
Adjusts the level.
BALANCE L15 — R15 (Preset: 0): Adjusts the left and right speaker output balance.
FADER R15 — F15 (Preset: 0): Adjusts the rear and front speaker output balance.
SUB-W SET ON *: Turns on the subwoofer output. ; OFF:
Cancels.
DETAIL SET LPF SUB-W: THROUGH *: All signals are sent to the subwoofer. ; 85HZ/ 120HZ/ 160HZ: Frequencies
higher than 85 Hz/ 120 Hz/ 160 Hz are cut off.
SUB-W PHASE: REV
(180°)/ NORM
(0°)
*: Selects the phase angle of the subwoofer output to be in line
with the speaker output for optimum performance. (Selectable only if a setting other than
[THROUGH] is selected for [LPF SUB-W].)
SUPREME SET: ON *: Creates realistic sound by interpolating the high-frequency components that are lost
in MP3/WMA audio compression. ; OFF: Cancels. (Selectable only when playback an MP3/
WMA disc.)
VOL OFFSET:
(Preset: 0)
–8 — +8 (for AUX) ; –8 — 0 (for other sources): Presets the volume adjustment level of
each source. The volume level will automatically increase or decrease when you change the
source. (Before making an adjustment, select the source you want to adjust.)
KDC-3051R/ KDC-3051G/ KDC-315A/ KDC-315R/ KDC-3251RY only:
[SUB-W LEVEL/ SUB-W SET/ LPF SUB-W/ SUB-W PHASE] is selectable only if [SWITCH PRE] is set to [SUB-W]. (page 4)
[SUB-W LEVEL/ LPF SUB-W/ SUB-W PHASE] is selectable only if [SUB-W SET] is set to [ON].
Select a source before making a source tone memory adjustment, [BASS ADJUST/ MID ADJUST/ TRE ADJUST].
Function settings
EN02-15_KDC-3051R[E]f.indd 10EN02-15_KDC-3051R[E]f.indd 10 8/2/10 9:17:31 AM8/2/10 9:17:31 AM
130.com.ua
Autogood products Internet store “130”