Filter
Top Products
Function of the KDC-V7018R
You can automatically store all the receivable frequencies in
the band currently being listened to, and then recall them with
the touch of a button later. This function is especially useful
when you are travelling and do not know what stations are
available. Up to six frequencies can be stored this way.
Display and setting:
Select the display "Auto-Memory" during the selecting function
in the menu system.
Press either the 4 or ¢ button for at least two seconds to
start auto memory function.
The numbers of the preset station buttons showed in order.
When all the stations in a certain band are stored in the preset
memory, the auto memory entry stops. The tuner then plays
the last station received.
•When the AF function is turned on while auto memory entry
takes place, only RDS stations (i.e., stations with RDS
capability) are stored. RDS stations that have been preset for
FM1 cannot also be preset in FM2 or FM3.
• When the local seek function is turned while auto memory
entry takes place, stations with poor reception are not stored.
• When the Traffic Information function is on , only the local
traffic information station frequency will be stored.
NOTE
2
1
Auto Memory Entry <In Tuner mode>
Function of the KDC-V7018R
You can choose from three tuning modes: auto seek, preset
station seek, and manual. The "AUTO 1" indicator lights up
when auto seek tuning is selected, and the "AUTO 2" indicator
lights when preset station seek tuning is selected.
Display and setting:
"Auto 1" : Auto seek tuning mode (Default setting)
"Auto 2" : Preset station seek tuning mode
"Manual" : Manual tuning mode
Selecting Tuning Mode <In Tuner mode>
Function of the KDC-V7018R
With the local seek function turned on, auto seek tuning skips
stations with relatively poor reception.
Display and setting:
"Local.S ON" : The local seek function is on.
"Local.S OFF" : The local seek function is off. (Default setting)
Local Seek Function
<In FM reception of Tuner mode>
Function of the KDC-V7018R
You can arrange to have news bulletins interrupt your current
listening source, including other radio stations. When the
News Bulletin function is on, the PTY News Timeout setting
allows you to set the interval during which further news
interruption cannot take place. You can adjust the PTY news
interruption period from 10 to 90 minutes for each journey.
Display and setting:
"News OFF" (Default setting) , "News 00min" - "News 90min"
(min= minutes)
:When you select the news interruption timeout interval, the
News function turns on and the NEWS indicator lights up.
When a news bulletin is received, "News" will be displayed
and reception will begin at the preset volume.
• If you choose the "20min" setting, further news bulletins will
not be received for 20 minutes once the first news bulletin is
received.
• This function is only available if the desired station sends PTY-
code for news bulletin or belongs to <Enhanced Other
Network>-Network sending PTY-code for news bulletin.
• If you turn on the news bulletin function in the MW/LW band,
the band is switched automatically to the FM band.
However, the MW/LW band is not returned to when you turn
off the function.
NOTE
News Bulletin Function with PTY News Timeout
Setting
Menu settings
— 32 —
English