Kenwood KDC-W5141U Car Stereo System User Manual


 
22
|
KDC-W5641U/KDC-W5541U/KDC-W5141U/KDC-W5041U/KDC-W4141/KDC-W4041
Troubleshooting Guide
Some functions of this unit may be disabled by
some settings made on this unit.
! • Cannot set up the subwoofer.
• Cannot set up the High Pass Filter.
• Cannot set up the Fader.
• No Audio control effect on AUX.
• Preout is not set to subwoofer. “SWPRE” of
<Menu System> (page 11)
• “Subwoofer output” of <Basic Operation> (page 4)
is not set to On.
• The Dual zone function is enabled. <Audio
Setup> (page 6)
! Cannot set up the subwoofer phase.
The Low Pass Filter is set to Through. <Audio
Setup> (page 6)
! • Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear speakers.
The Dual zone function is disabled. <Audio
Setup> (page 6)
! • Cannot register a security code.
• Cannot set up Display Illumination Control.
<Demonstration mode Setting> (page 13) is not
turned off.
! Cannot set up the Power-off timer.
<Security Code> (page 12) is not set.
What might seem to be a malfunction in your unit
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
Tuner source
? Radio reception is poor.
The car antenna is not extended.
Pull the antenna out all the way.
Disc source
? The specified disc does not play, but another one
plays instead.
The specified CD is quite dirty.
Clean the CD.
The disc is loaded in a different slot from that
specified.
Eject the disc magazine and check the number
for the specified disc.
The disc is severely scratched.
Try another disc instead.
Audio file source
? The sound skips when an Audio file is being
played.
The media is scratched or dirty.
Clean the media, referring to the CD cleaning of
the section on <Handling CDs> (page 3).
The recording condition is bad.
Record the media again or use another media.