Filter
Top Products
12 English
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of slight
misoperation or miswiring. Before calling service, first check the following table for possible
problems.
PROBLEM POSSIBLE CAUSE SOLUTION
No sound.
(No sound from one side.)
(Blown fuse.)
The output level is too
small (or too large).
The sound quality is bad.
(The sound is distorted.)
• Input (or output) cables are
disconnected.
• Protection circuit may be
activated.
• Volume is too high.
• The speaker cord is shorted.
The input sensitivity adjusting
control is not set to the correct
position.
• The speakers wire are
connected with wrong + / -
polarity.
•A speaker wire is pinched by a
screw in the car body.
• The switches may be set
improperly.
• Connect the input (or output)
cables.
• Check connections by referring
to "Indicator".
• Replace the fuse and use lower
volume.
• After check the speaker cord and
fixing the cause of the short,
replace the fuse.
Adjust the control correctly
referring to “Controls”.
• Connect them properly checking
the + / - of the terminals and
wires well.
• Connect the speaker wire again
so that it is not pinched by
anything.
• Set switches properly by
referring to "System examples".
Specifications
Specifications subject to change without notice.
Audio Section
Max Power Output ............................................................................................................320 W × 2
Rated Power Output
Normal (4 Ω) (20 Hz – 20 kHz, 0.08 % THD)......................................................................60 W × 4
Normal (2 Ω) (1 kHz, 0.8 % THD) ......................................................................................90 W × 4
Bridged (4 Ω) (1 kHz, 0.8 % THD) ....................................................................................180 W × 2
Frequency Response (+0, –3 dB)..................................................................................5 Hz – 50 kHz
Sensitivity (rated output) (MAX.) ................................................................................................0.2 V
Sensitivity (rated output) (MIN.) ................................................................................................5.0 V
Signal to Noise Ratio................................................................................................................100 dB
Input Impedance........................................................................................................................10 kΩ
Low Pass Filter Frequency (12 dB/oct.) ............................................................50 – 200 Hz (variable)
High Pass Filter Frequency (12 dB/oct.)............................................................50 – 200 Hz (variable)
Bass Boost Circuit (90 Hz) ..............................................................................................OFF / +6 dB
General
Operating Voltage ..................................................................................14.4 V (11 – 16 V allowable)
Current Consumption (4 Ω, 10 % THD) ......................................................................................39 A
Dimensions (W × H × D) ......................................................................................285 × 57 × 268 mm
............................................................................................................11-1/4 × 2-1/4 × 10-9/16 inch
Weight ......................................................................................................................2.96 kg (6.5 lbs)
KAC-8401(M) 1English 02.11.14 10:38 AM Page 12