Filter
Top Products
— 7 —
Spectrum Analyzer Display Selection
You can select the display to enjoy sounds with eyes.
Switching the Spectrum Analyzer Display:
Each time you press the S.A button, the spectrum analyzer
display switches as follows;
▼
1 "SCAN MODE ON":Displays 2 to 9 are automatically
shown in succession for about five seconds each.
▼
2 "PEAK HOLD"
▼
3 "LASER"
▼
4 "H-SCOPE"
▼
5 "FIREWORKS"
▼
6 "SQUASH"
▼
7 "V-SCOPE"
▼
8 "BLIZZERD"
▼
9 "KISS"
▼
0 "SIDE WAVE"
▼
! "EQ CURVE":Equalizer curve
▼
@ "SPEANA OFF":Spectrum analyer off
Input Sensitivity Adjustment
Adjust this control according to the pre-out level of the centre
unit connected to this unit.
Removing the faceplate (see page 8)
Adjusting the input sensitivity volume.
Reattaching the faceplate (see page 8)
Refer to “Specifications” on the centre unit’s
instruction manual about the pre-out level.
If the input sensitivity is not adjusted
correctly, sound distortion may occur.
NOTE
3
2
1
MIN
MAX
Input sensitivity
increased.
Input sensitivity
decreased.
Automatic Dimmer Function
The display dims when the car's lights are turned on.
The dimmer function is not available for units if the dimmer
cable is not connected.
NOTE
Demonstration Function
You can give a demonstration of the spectrum analyzer and
the equlizer curves to know what displays this unit has.The
DEMO indicator lights up when the demonstration function is
on.
Starting Demonstration:
Pressing the S.A button for more than one second will turn on
demonstration mode.
Cancelling Demonstration:
Press the S.A button.
MIN
(4V)
MAX
(1V)
(2V)
(Value of input
sensitivity)