Filter
Top Products
— 23 —
Connecting Wires to Terminals
–
+
FRONT • L
FRONT • R
REAR • L
REAR • R
P.CONT.OUT
ANT.
CONT.
When only two speakers are being connected to the
system, connect the connectors either to both the front
output terminals or to both the rear output terminals (do not
mix front and rear). For example, if you connect the +
connector of the left speaker to a front output terminal, do
not connect the - connector to a rear output terminal.
2CAUTION
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
2WARNING
FM/AM antenna input
Rear left output (White)
Rear right output (Red)
Fuse (10A)
KENWOOD disc changer control input
Wiring harness
(Accessory1)
White/Black
Gray/Black
Green/Black
Purple/Black
White
Gray
Green
Purple
To front left
speaker
To front right
speaker
To rear right
speaker
To rear left
speaker
Power control/Motor antenna
control wire (Blue/White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
Ignition key
switch
Car fuse box
(Main fuse)
ACC
Car fuse
box
Battery
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal
when using the optional power amplifier, or to
the antenna control terminal in the vehicle.
To connect the Disc changer,
consult your Disc changer manual.
NOTE
KMD-44_U.S_ver2 01.1.9 11:28 AM Page 23