Filter
Top Products
Function of the KRC-608
This function allows you to adjust the setting that is recalled
with the sound coordinate system, according to types of
speakers.
Press the SRC button repeatedly to select the standby mode.
"ALL OFF" is displayed when the standby mode is selected.
Press the AUD button to enter the mobile preset plan mode.
Press either the 4 or ¢ button to select the type of
speaker. The setting switches as follows.
Off / For the OEM speaker / For 6/6x9 in. speaker /
For 5/4 in. speaker
Press the AUD button to end the mobile preset plan mode.
• This mode is available only when the Sound coordinate system
is on. (page 25)
• When you change the setting of type of speaker, the bass and
treble tone settings are returned to original levels.
NOTE
4
3
2
1
Mobile Preset
"V OFFSET/VOS" : Set the sound level of the each source
selected by adjusting the level difference
between the basic sound level and the
required level.
Setting values: - 8 – ±0
“Fader/FAD” : Adjust the fader level.
Setting values: Front 15 – Rear 15
“Balance/BAL” : Adjust the balance level.
Setting values: Left 15 – Right 15
“Treble/TRE” : Adjust the treble level.
Setting values: - 8 – + 8
“Bass/BAS” : Adjust the bass level.
Setting values: - 8 – + 8
— 7 —
"ec4/EC4" : Recalling the kenwood preset sound setting
Press the preset buttons (#1-6).
Settings:#1;Flat, #2;Rock, #3;Pops/Top40, #4;Jazz, #5;Easy,
#6;Scan of #1-5 (KRC-608 only)
• This mode is available only when the Sound coordinate system
is on. (page 25)
• You can call the following settings with this function; bass
center frequency, bass level, bass quality factor, bass extension,
treble center frequency, and treble level setting. Their setting
values are different depending on the setting of the mobile
preset plan mode.
NOTE
KRC-608(K)_U.S_r2 00.12.27 0:11 PM Page 7