Filter
Top Products
12
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
BLUETOOTH®
You can operate Bluetooth devices using this unit.
Connect the microphone
If you turn off the unit or detach the control panel
during a phone call conversation, the Bluetooth
connection is disconnected. Continue the
conversation using your mobile phone.
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
– Object Push Profile (OPP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
Adjust the microphone
angle
Secure using cord clamps (not
supplied) if necessary.
MIC (Microphone input terminal)
Microphone (supplied)
Rear panel
• Pairing request (via Bluetooth) is
automatically activated if an iPhone/iPod
touch is connected through the USB input
terminal. (Applicable only if
[AUTO PAIRING]
is
set to
[ON]
.)
( 16)
Press the volume knob to pair once you
have confirm the device name.
Bluetooth test mode
You can check the connectivity of the
supported profile between the Bluetooth
device and the unit.
• Make sure there is no Bluetooth device
connected.
1 Press and hold .
“PLEASE PAIR YOUR PHONE” appears.
2 Search and select this unit model name
(KDC-X5**/ KDC-BT5**U/ KMR-D5**BT)
on the Bluetooth device.
3 Operate the Bluetooth device to confirm
pairing.
“TESTING” flashes on the display.
The connectivity result (OK or NG) appears
after the test.
PAIRING: Pairing status
HF CNT: Hands-Free Profile (HFP)
compatibility
AUD CNT: Advanced Audio Distribution
Profile (A2DP) compatibility
PB DL: Phonebook Access profile (PBAP)
compatibility
• To cancel check mode, press and hold
B SRC to turn off the unit.
Pair a Bluetooth device
When connecting a Bluetooth device to
the unit for the first time, perform pairing
between the unit and the device. Once the
pairing is completed, the Bluetooth device
will remain registered in the unit even if you
reset the unit.
• Up to five devices can be registered (paired)
in total.
• A maximum of two Bluetooth phones
and one Bluetooth audio device can be
connected at any time.
• This unit supports Secure Simple Pairing
(SSP).
• Some Bluetooth devices may not
automatically connect to the unit after
pairing. Connect the device to the unit
manually. Refer to the instruction manual of
the Bluetooth device for more information.
1 Press B SRC to turn on the unit.
2 Search and select this unit model name
(KDC-X5**/ KDC-BT5**U/ KMR-D5**BT)
on the Bluetooth device.
“PAIRING”
“PASS XXXXXX” Device
name
“PRESS” “VOLUME KNOB”
scrolls on the display.
3 Press the volume knob to start pairing.
“PAIRING OK” appears when pairing is
completed and “
” will light up when the
Bluetooth connection is established.
• For some Bluetooth devices, you may need
to enter the Personal Identification Number
(PIN) code immediately after searching.
EN_KDC_X598_KWK0_f.indd 12EN_KDC_X598_KWK0_f.indd 12 8/11/2013 5:11:39 PM8/11/2013 5:11:39 PM