Kicker CX300.4 Car Amplifier User Manual


 
2
CX.4-SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the amplifi er.
The KICKER CX Amplifi ers are capable of space-saving vertical mounting. Use a 2.5mm hex key (Allen wrench)
to loosen the endpanel, remove the existing brackets, then insert and tighten the double-slotted brackets to the
amplifi er as illustrated on the next page.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Serial Number:
Model: CX300.4
RMS Power
@ 14.4V, 4 stereo, 1% THD+N
@ 14.4V, 2 stereo, 1% THD+N
@ 14.4V, 4 bridged, 1% THD+N
40W x 4
75W x 4
150W x 2
Length | in. [mm] 12-7/16 [320]
Height | in. [mm] 2-3/8 [60]
Width | in. [mm] 7-3/16 [180]
Frequency Response ± 1dB 10Hz–20KHz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mV–5V
High Level: 250mV–10V
Electronic Crossover Selectable: HI, LO or OFF; Variable 50–200Hz @ 12dB/Octave
Bass Boost Variable 0–12dB @ 40Hz
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: CX300.4
2012 CX 4-Channel Amps Rev F.indd 22012 CX 4-Channel Amps Rev F.indd 2 6/22/2012 2:45:32 PM6/22/2012 2:45:32 PM