Filter
Top Products
35
SX .1 Series Amplifiers
Specifications
Performance
Model SX650.1 SX1250.1
RMS Power
In Watts, All Channels Driven
@ 13.8V, 4Ω Mono, 1.5% THD 325 x 1 na
@ 13.8V, 2Ω Mono, 1.5% THD 650 x 1 625 x 1
@ 13.8V, 1Ω Mono, 1.5% THD na 1250 x 1
Dynamic Power
In Watts, All Channels Driven
@ 14.4V, 4Ω Mono, 1.5% THD 325 x 1 na
@ 14.4V, 2Ω Mono, 1.5% THD 650 x 1 625 x 1
@ 14.4V, 1Ω Mono, 1.5% THD na 1250 x 1
Length With EndKaps 16” 22.50”
(40.64cm) (57.15cm)
Fusing 30A x 2 150A x 1 external
Recommended Power & Ground Wire 4 GA 2 GA
34
SX .1 Series Amplifiers
Specifications
Kompressor
Here is a brief explanation of each KOMPRESSOR setting.
Contour - This preset applies expansion below the threshold
point to provide a fuller sound at lower volume levels. Effect
decreases at higher volume levels. Nice effect for someone
wanting a fuller sound at low to moderate listening levels.
ATTACK - This preset applies expansion above the threshold
point to provide a nice quick punch or attack to the music.
Effect increase with higher volume levels. Like music with a
quick and punchy sound? Give this one a try.
Red-line - Provides a quick clamp to dynamic peaks while
still allowing a full sound to come through. Effect increases
at higher volume levels. Like to play it loud but want to
protect your speakers? Want low level details to come
through over road noise? Want a more even volume level to
your music? All can be achieved with this preset.
OFF - Pretty much says it all. This turns the KOMPRESSOR
off. This is the factory default setting.
After selecting your KOMPRESSOR setting you can adjust its
effect using the KOMPRESSOR ADJUSTMENT (
KOMP ADJ.)
setting located in the SYSTEM menu. There you can change
the threshold point for each of these settings to customize
the KOMPRESSOR effect to fit your speakers, car or personal
tastes.
The possibilities are almost endless! Tweak away!