Filter
Top Products
D3200 EasyStart
3
! The default setting is MATCH. Holding down the JUMP/MATCH key while adjusting a knob or fader temporarily
switches to JUMP operation.
Settings for the ClickPoint cursor speed and Knob/fader “Jump/Match” settings can be made in the SYSTEM
menu. Press the SYSTEM MIDI key to the right of the display, click the “Control” tab in the display then make
your selections.
The D3200’s Transport controls are shown as follows:
[ ] = RECORD [] = PLAY [] = STOP [] = REWIND [] = FAST FORWARD
Modes and Features Tour
1. First, load the demo song: Press the SONG key, and then click the “” popup button in the display, next to
the current song name > Select “001: I’d Be A Fool”, and then click “OK”.
2. Click “Copy” in the display then click “Yes” and “OK” when completed.
3. Now to un-protect the copied demo song: Click “Protect” > Click “OFF”, and then click “OK”. Note that the
rest of the song edit functions are now visible and accessible in the display.
4. Press the [
] key to start playback of the demo song. Slowly raise the MONITOR or PHONES level knob to a
comfortable listening position.
The [METER] key
The Meter Track View displays regions of audio, levels for playback tracks, effects, output levels as well as
the currently selected virtual tracks, track names and locate points.
As the song continues to play…
1. Press the METER key located to the left of the top row of Matrix Knobs.
2. You can change this view to display CH-Input, Pre or Post Fader meter levels, and also select your choice of
Track or Fader views. Try it: Click the “
” popup button in the upper left corner of the display > under Select
View: click “FaderView”, and then click “OK”. Now you’re viewing meter levels in addition to the Fader and
Pan settings for the song! To view tracks 17-32, press the 17-32 channel selection key (above channel 13
fader).
The [CH VIEW] Key
This screen displays the settings and status of a single channel. Level, pan, effects, EQ, etc. are all
accessible on one page!
1. Press the [] key to stop song playback.
2. Press the CH VIEW key (located to the left of the Knob Matrix) > Select different channels by pressings the
channel keys above the faders (the selected channel key lights yellow), or click the “CH” in the upper left
corner of the display and use the DIAL or + and - keys to change channels. The Knob Matrix is active here for
control of the selected channel’s Effect send levels and EQ. Try it.!
3. Press the TAB PAGE>/YES key to view the “Ch Routing” tab. Here you can view the signal flow for the
selected channel.