Filter
Top Products
VA-4 - Connecting the VA-4 7
4 Connecting the VA-4
Always switch off the power to each device before connecting it to your
VA-4. After connecting your VA-4, connect its power and then switch
on the power to each device.
To connect the VA-4 as illustrated in the example in
Figure 3:
1. Connect a balanced stereo audio source (for example, a set top box: source
1) to the left and right channel 1 IN XLR connectors.
2. Connect a balanced stereo audio source (Source 2) to the left and right
channel 2 IN XLR connectors.
3. Connect the left and right channel 1 OUT XLR connectors to a balanced
stereo audio acceptor (Acceptor 1).
4. Connect the left and right channel 2 OUT XLR connectors to a balanced
stereo audio acceptor (Acceptor 2).
5. Connect a PC (or other control device) to the RS-232 9-pn D-sub port, if
control via RS-232 is required (see
Section 4.1
6. Connect the power cord to the mains electricity (not shown in
).
Figure 3).
7. Select the stereo channel (1 or 2) by pressing the SELECT button, and set
the level using the + and – buttons (as required).
i