Filter
Top Products
8
• SOUND ADJUSTMENT
Press SEL button (11) to select the desired adjustment mode. The adjustment
mode will change in the following order:
By pressing VOLUME button (12) or VOLUME button (13), it is possible to
adjust the desired sound quality.
• LOUDNESS
Press LOU/BND button (14) for several seconds to reinforce the bass output and
display will show “LOUD”.
Press it for several seconds again to release this function.
• SET THE CLOCK
Holding down the DSP button (16) until the clock is shown on the LCD display and
flashed. Then press the MAN/SEK button (18) to change hours or MAN/SEK
button (17) to change minutes.
• SELECT MODE
Press MOD button (6) to choose desired listening mode.
(e.g. radio mode to CD mode)
• SUBWOOFER
Press
MOD/SW
button (6) for several seconds to toggle subwoofer output. When subwoofer
on, display will show
“ SW”
. Press it again for several seconds to release this
mode.
• MUTE
Press MUT button (10) to silence the receiver. Press it again to resume listening.
• LIQUID CRYSTAL DISPLAY
Exhibit current frequency and activated functions on the display (8).
• EQUALIZATION
Press EQ button (20) to turn on equalization function and to select desired audio
mode. There are five kinds of mode as below:
• REMOTE SENSOR
Point the remote control handset to the remote sensor IR-sensor (26).
Press the function keys on the handset to control the system.
• FLASHING LED
If the front panel does not install in the unit, the LED (25) will be flashing.
• RESET
Reset button (27) is placed on the front panel and must be activated with either a
ball point pen or thin metal object. The reset button is to be activated for the
following reasons:
- Initial installation of the unit when all wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
Note: If press RESET button (27), the unit can’t work yet, please use a cotton swab
soaked in isopropyl alcohol to clean the socket on the back of the front panel.
Volume Bass Treble Balance Fader
FLAT CLASSICS POP M ROCK M DSP OFF