Filter
Top Products
38
206-4118
Some Quick and Easy Tips for Resolving Problems
Software Problems
Cannot direct enter
channel number or “No
Signal” appears.
Channel not included in Channel Scan
in TV controller.
After 2-5-5 + MENU, only channels included in TV controller
will appear. If channel is available, it can be added to
Channel Scan. If it is not available, the “No Signal” mes-
sage appears on the TV screen.
Power
No Power. See troubleshooting flow chart.
Display Panel Picture
No Picture. Display panel is turned off. • Turn TV ON.
• Power failure?
Antenna/cable not connected. Connect antenna/cable signal to TV (see Owner's Manual).
Connections incorrect. Check connections on TV (see Owner's Manual).
MPI not connected. If applicable, connect MPI cable to MPI device.
Encrypted program. Try another channel.
Wrong tuning band. Adjust Installer Menu settings.
Erratic Operation
Installer Menu setup. Wrong Installer Menu settings. Adjust Installer Menu settings as required.
Remote Control
Remote doesn’t work. Remote not in TV Mode. Use Mode key to select TV; puts remote into TV Mode.
Not aimed at IR remote sensor. Point remote at TV’s IR receiver on TV.
Remote too far from IR sensor. Move remote closer to TV’s IR receiver or darken room.
MPI not connected. If applicable, connect MPI cable to MPI device.
IR path to TV’s receiver obstructed. Remove obstructions.
Weak batteries. Replace batteries.
Wrong battery polarity. Check that “+” and “-” match in battery compartment.
Too much light in room. Dim room light.
Wrong Installer Remote. Requires compatible Installer Remote. Contact your LG dealer.
Picture Reception
Normal picture,
poor or no sound.
Audio muted. Press MUTE or use Volume Up key to increase sound level.
Broadcast problem. Try a different channel.
Note: For other problems not caused by the TV, refer to the other devices’ operating guide(s).
Reference: General Troubleshooting
Symptom Possible Cause(s) Possible Solution(s)