Filter
Top Products
82
206-4235
RGB IN (PC)
ANTENNA/
CABLE IN
SPEAKER OUT
LINE OUT
RESET
UPDATE
RJP
GAME CONTROL
/ MPI
RS-232C
(SERVICE & EXT POWER)
LAN
AUX LAN
/
DVI
IN
1
(ARC)
..........
2
..........
/ DVI IN
3
..........
AUDIO IN
(RGB/DVI)
AV IN
OPTICAL AUDIO OUT
SERVICE ONLY
TV-LINK CFG
Reference: LP870H Rear and Side Jack Panels
RGB IN (PC)
Connection for RGB
output from PC.
UPDATE
Restricted to software
updates.
RESET
Initiates a hardware reset and
turns the TV OFF.
GAME CONTROL/MPI
When the TV/EBL is in Pass-through Mode, the
MPI function enables an external MPI control
device (i.e., clone programmer, VOD/PPV STB,
etc.) to control the TV. Game Control—EBL in
LodgeNet PPV Mode only.
AUDIO/VIDEO IN
(3.5 mm jack)
Connection for audio/
video output from
external device.
SPEAKER OUT / LINE OUT
(3.5 mm jack) Connect external audio
(xed speaker, variable speaker, or xed
line level [amplier]) equipment. See
Reference section, “External Stereo
Speaker Setup,” for further information.
RS-232C (SERVICE & EXT POWER) *
Typically used for downloading
software updates, etc.
AUDIO IN (RGB/DVI)
(3.5 mm jack) Audio
connection for RGB
or DVI device.
RJP
Connection for Remote
Jack Pack (RJP) Control
cable.
HDMI/DVI IN
Connection for HDMI/DVI
output from external device.
ANTENNA/CABLE IN
Connect to Antenna/
CATV.
SERVICE ONLY
Restricted to service updates.
TV-LINK CFG
(3.5 mm jack) Use for direct PC-to-TV
FTG configuration.
Side Jack Panel
USB IN
1 (Hub) 2
USB IN 1 & 2
Insert USB memory device
for software updates, cloning
purposes, FTG Mode via
CPU configuration, picture/
music entertainment, etc., as
applicable.
OPTICAL AUDIO OUT
Use for amps and home theater systems.
Note: When the TV is OFF, this port is not
enabled.
AUX LAN & LAN
Use for video IP
and/or network
connections.
* For specific applications, the RS-232 (DB9) port may be used to
provide +12v/1A external power (for example, to an external MPI
control device). In this case, Installer Menu item 118 POWER
SAVINGS must be set to 9—both the b-LAN module and the
GAME CONTROL/MPI port circuitry are always powered, and the
external power is provided on pin 9 of the RS-232 port.