Lightning Audio B2.250.1 Car Amplifier User Manual


 
7
Installation
9. Connect the speakers. Strip the speaker wires 1/2" and insert into the speaker terminal
and tighten the set screw to secure into place. Be sure to maintain proper speaker polarity.
DO NOT chassis ground any of the speaker leads as unstable operation may result.
10. Perform a final check of the completed system wiring to ensure that all connections are
accurate. Check all power and ground connections for frayed wires and loose connections
which could cause problems.
NOTE: Follow the diagrams for proper signal polarity.
CAUTION: These amplifiers are not recommended for impedance loads below
2 stereo and/or 4 bridged (mono).
!
SPEAKER
12V
15A 15A
REM GND
FUSE
+
+
-
JUICE
BOOST X-OVER GAIN PROTECT
INPUT
POWER
L
L
R
HI INPUT
MIN MAX40 2500dB 12dB
+-
R
+-
JUICE
BOOST
INPUT
PROTECT
POWER
GAIN
MIN MAX
X-OVER FILTER
40 400
FLAT 50Hz
0dB 12dBHIGH LOW
L
HI INPUT
+-
R
+-
L
25A
FUSE
12V REM GND
+
SPEAKERS
+-
R
+-
BRIDGED
+
-
L
25A
FUSE
12V REM GND
+
SPEAKERS
+-
R
+-
BRIDGED
+
-
Power
Connection
CAUTION: Use only one input
configuration. Using both
the RCA and High Level
inputs will cause
undesirable operation.
!
*NOTE: When using High Level Inputs, if audible engine noise is present, connect the Black
wire to chassis ground. If noise is still present, contact your local authorized dealer or
Lightning Audio customer service.