Filter
Top Products
11
CD Player
Signal/Noise Ratio . . . . . . . . . . . . . . . . > 86 dB
Frequency Response . . . . . . . . 20 Hz – 20 kHz
Channel Separation . . . . . . . . . . . . . . . > 65 dB
D/A Converter . . . . . . . . . . . . . . . . . . . 1 Bit/CH
FM Tuner
Tuner Range . . . . . . . . . . . . 87.5 – 107.9 MHz
FM Mono Sensitivity . . . . . . . . . . . . . . . 12 dBf
50 dB Quieting Sensitivity (Stereo) . . . . 16 dBf
Stereo Separation @ 1 kHz . . . . . . . . . . 40 dB
AM Tuner
Tuner Range . . . . . . . . . . . . . . 530 – 1720 kHz
Amplifier
Total System Power . . . . . . . . 160 Watts Peak
Power Output . . . . . . . . . . . . . . . . . . . 4 x 40W
General
Power Supply . . 11-16 VDC, Negative Ground
Speaker Output Impedance . . . . . . 4 – 8 Ohms
Fuse . . . . . . . . . . . . . . . 15 Amp Fast Blow ATO
Dimensions . . . . . . . . . . . . . . . . . . .7" x 7" x 2"
. . . .178 mm (W) x 178 mm (D) x 55 mm (H)
Specifications are subject to change without notice.
Specifications
Final Installation - Method B
Hook
Screw
Dashboard or Console
Side View Showing
Screw Holes Marked
T, N
Screw
Factory Radio
Mounting Bracket
DIN Rear-Mount
If your vehicle is a Nissan or Toyota, fol-
low these mounting instructions:
Use the screw holes marked T (Toyota),
N (Nissan) located on both sides of the
unit to fasten the unit to the factory radio
mounting brackets supplied with your
vehicle.
To fasten the unit to the factory radio
mounting brackets.
1. Use a screwdriver to loosen the hook’s
screws on the front left and right
sides of the unit and remove the
hooks.
2. Align the screw holes on the bracket
with the screw holes on the unit, and
then tighten the screws (5 x 5mm) on
each side.
Note: The outer trim ring, sleeve and the
metal strap are not used for Method B
installation.
M3200CD-UM (A&D).qxp 4/26/06 14:27 Page 11