Filter
Top Products
Surround sound and other settings
09
45
En
English
Français
Deutsch
Nederlands
Italiano
Español
•
DRC Off
– No dynamic range adjustment
(use when listening at higher volume)
•
DRC Mid
– Mid setting
•
DRC High
– Dynamic range is reduced
(loud sounds are reduced in volume while
quieter sounds are increased)
Note
• This setting works only with Dolby Digital
and some DTS soundtracks. For other
sources, you can create a similar effect
using the Midnight mode (see
Using Quiet
and Midnight listening modes
on page 27).
Dual mono setting
Specifies how dual mono encoded Dolby
Digital or DTS soundtracks should be played.
You can also use this setting to switch the
audio channel on DVD-RW discs recorded with
two separate soundtracks.
•
L-Ch1 R-Ch2
– Both channels are played
through the front speakers
•
Ch1 Mono
– Only channel 1 is played
•
Ch2 Mono
– Only channel 2 is played
Note
• On the
Ch1 Mono
and
Ch2 Mono
settings
the sound comes only from the center
speaker (or from the front speakers if
listening in
STEREO
mode).
• This setting works only with dual mono
encoded Dolby Digital or DTS soundtracks.
See the disc packaging for channel
information.
LFE attenuator setting
Dolby Digital and DTS audio sources include
ultra-low bass tones. Set the LFE attenuator as
needed to prevent the ultra-low bass from
distorting the sound.
•
LFE ATT 0
– The LFE channel is played with
no attenuation
•
LFE ATT 10
– LFE channel is attenuated by
10dB
•
LFE OFF
– LFE channel is not played
SR+ control options for Pioneer
plasma displays
You only need to make the following settings if
you have connected a Pioneer plasma display
to this unit using an SR+ cable (not supplied).
Note that in the function settings below, the
number of video inputs may change depending
on your display. See also
Using this unit with a
Pioneer plasma display
on page 57.
Control mode setting
•
SR+ Off
– Switches SR+ off (this unit and
the plasma display work independently)
•
SR+ On
– Switches SR+ on (this unit
sends control signals to the plasma
display)
The following settings are only available if the
Control mode setting (above) is switched on.
Volume control setting
•
Vol C.Off
– This unit does not control the
volume of the plasma display
•
Vol C.On
– When this unit is switched to
an input that used the plasma display
(DVD, for example), the volume on the
plasma display is muted so only sound
from this unit is heard.
Function setting for DVD input
•
DVD -> OFF
/
PDP1–5
/
PDPTV
– Matches
the
DVD
function of this unit with a
numbered video input on the plasma
display. For example,
DVD -> PDP2
matches the
DVD
input with video input 2
on the plasma display.
XV-DV323.book 45 ページ ２００４年１月１３日 火曜日 午後７時５７分