Magnavox 50ME313V/F7 A Car Satellite TV System User Manual


 
4 Use your TV
Switching on your TV and putting it in Standby
mode
* Key on Rear
Remote Control
TV
To Turn the TV On from Standby or Off to Standby
Press B on the Rear panel or the Remote Control.
Note(s)
Energy Consumption contributes to air and water pollution. When the AC Power Cord
is plugged in, your TV consumes energy with a very low standby Power Consumption.
Adjusting Volume
Remote Control
TV
* Key on Rear
To decrease or increase Volume
Press VOL J / K on the Rear panel or press VOL + / – on the Remote
Control.
VOL J(-) : Volume Down
VOL K(+) : Volume Up
To mute or unmute sound
Press D on the Remote Control to mute the sound.
Press D again or VOL + / – to recover the original sound.
Switching Channels
TV
Remote Control
* Key on Rear
To select Channels by using CHI / H or CH + / –
Press CH I (Down) / H (Up) on the Rear panel or press CH + / – on
the Remote Control.
To select Channels by using the NUMBER keys
Digital TV Operation
For Digital channels, press a number followed by a dot “” and the
corresponding sub channel number.
When selecting Digital channel 11.1
Be sure to press before entering the subchannel number.
Cable / NTSC (Analog) TV Operation
When selecting Cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
To select the non-memorized channels, use the NUMBER keys.
No signal will appear on the TV screen after the subchannel broadcast is over.
Audio only program message will appear on the TV screen, when you receive only a
sound signal.
16 .English
Continued on next page.