Filter
Top Products
Mono Amplifiers
Q1.1500D
6
Interconnect cable checklist:
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. Control checklist:
Refer to the section “Settings for Best Performance”
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,
simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers
Minimum final loudspeaker impedance: 1-Ohm.
which have multiple positive and negative connections for ease of wiring. The 2 positives
are the same internally and the 2 negatives are the same internally.
DESIGNATED
MONO OUTPUT
FROM HEAD UNIT
POWER INPUT
BATT+12V REM GND
SPEAKER OUTPUT
- - + +
FUSE
MONO
SUBWOOFER
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY + 12 Volts
VIA FUSE
OUTPUT
INPUT
R
SLAVE INPUT
BALANCED
INPUT
MASTER OUTPUT
L
REMOTE
MBQR-2
MIN MAXX
INPUT OUTPUT
SLAVE MASTER
PROTECT
POWER
CLIP INDICATOR
CONTROL
GREEN-PRE CLIP
AMBER-SOFT CLIP
RED-HARD CLIP
LEVEL
BASS BOOST
PARAMETRIC BASS EQ
PRE-AMP X-OVER
PHASE SHIFT
BANDWIDTH
BASS FREQUENCY
SUBSONIC
Q-LINK
LOW PASS
0dB
9V
0
WIDE
30Hz
15Hz
35Hz
12dB
0.2V
180
NARROW
80Hz
35Hz
200Hz