MB QUART ONX4.60 Car Amplifier User Manual


 
OUTPUT INPUT
L L
R R
POWER
PROTECT
6V 0.2V
LEVEL
15Hz 35Hz
SUBSONIC
REMOTE
30Hz 250Hz
LOW PASS
0dB 10dB
BASS EQ
Mono Amplifiers
ONX1.1000D / ONX1.1500D
7
FEATURES:
- 1 Set of RCA inputs
- LEVEL: Variable sensitivity from 0.2V to 6V
- BASS EQ: Adjustable 45Hz bass boost from 0dB to 10dB
- SUBSONIC: Variable from 15Hz to 35Hz
- LOW PASS: Variable from 30Hz to 250Hz
- POWER LED: Indicates the powered up and turned on condition
- PROTECTION LED: Indicates a high voltage, low voltage, short circuit,
hard clip, over heating or DC fault condition.
- LINE OUTPUT: Full range RCA pass through.
Interconnect cable checklist:
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables. Control checklist:
Refer to the section “Settings for Best Performance”
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,
simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers
Minimum final loudspeaker impedance: 1-Ohm.
which have multiple positive and negative connections for ease of wiring. The 2 positives
are the same internally and the 2 negatives are the same internally.
ONYX
POWER INPUT
GND REM BATT+12V
SPEAKER OUTPUT
- - + +
FUSE
MONO
SUBWOOFER
REMOTE TURN-ON
CHASSIS GROUND
TO BATTERY + 12 Volts
VIA FUSE
DESIGNATED
MONO OUTPUT
FROM HEAD UNIT
MBQR-2
MIN MAXX
OUTPUT INPUT
L L
R R
POWER
PROTECT
6V 0.2V
LEVEL
15Hz 35Hz
SUBSONIC
REMOTE
30Hz 250Hz
LOW PASS
0dB 10dB
BASS EQ