Filter
Top Products
10
OPERATION
CROSSOVER
Filter Switch
Placing the switch in the ON position (In Position) sets the
amplifier to the All Pass mode, preventing any crossover
adjustment, allowing all frequencies to pass. Adjustments
made to the Multiplier switch or Frequency Adjuster are
bypassed.
Frequency Switch
Placing the switch in the HPF position (In Position) sets the
amplifier to the High Pass mode, enabling frequencies
above the cut-off point to pass.
Placing the switch in the LPF position (Out Position) sets
the amplifier to the Low Pass mode, enabling frequencies
below the cut-off point to pass.
Multiplier Switch
This switch sets the multiplier for the crossover frequencies.
Placing the switch in the x10 position (In Position) sets the adjustable crossover frequency to 500-5KHz
(5000Hz).
Placing the switch in the x1 position (Out Position) sets the adjustable crossover frequency to 50-500Hz.
Frequency Adjustment
After setting the Frequency Switch and Multiplier Switch, use the Frequency Adjuster to set the desired cut-
off point.
Turning the adjuster counter-clockwise decreases the set frequency.
Turning the adjuster clockwise increases the set frequency.
Quick Setting: Decrease the crossover frequency all the way down. With the system playing, increase the crossover
frequency up slowly until the desired crossover point is achieved.
GAIN
Do the following individually for each channel.
Turning the adjuster clockwise decreases the set gain.
Turning the adjuster counter-clockwise increases the set gain.
1. To adjust the gain setting, turn the amplifier gains all the way down (clockwise).
2. Turn the source unit volume up until distortion is audible and then turn it down a bit until the distortion
is inaudible. This will be about all the way up on most source units.
3. Increase the amplifier gain setting until adequate volume is achieved or clipping is noted by the LED
indicators. Turn the gain down slightly if clipping is indicated.
Most quality source units do not distort, so the volume can be used at maximum setting.
NOTE: Best signal to noise and dynamic range are realized with the gain at minimum. Most users find
adequate gain and volume is achieved at about halfway in the adjustment range.
CAUTION: Avoid setting the amplifier gain very high as noise and distortion will increase
significantly.
NOTE: For a more in depth setting procedure, contact MB Quart Technical Support.