Filter
Top Products
Cut and remove all mounting tabs on Radio
Housing #1 EXCEPT tabs "C". The
mounting tabs can be identified by the
stamped letter on the back of each tab. Skip
to the Installation Instructions for ALL
VEHICLES on Page #5.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws from each side of the radio trim
bezel. Remove the ashtray and (1) screw
from the rear support tab. Remove the radio
trim bezel/sub-bracket assembly. Remove
(4) screws securing the sub-bracket to the
back of the radio trim bezel. Loosen (2)
screws on top of the bezel and remove the
sub-bracket from the bezel.
1
MAZDA B-Series Pickup 1986-93
2
"C"
3
4
"C"
"A"
"A"
"A"
"A"
"A"
"A"
Cut and remove all mounting tabs on Radio
Housing #1 EXCEPT tabs "A". The
mounting tabs can be identified by the
stamped letter on the back of each tab. Skip
to the Installation Instructions for ALL
VEHICLES on Page #5.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Reach
behind the console and remove (2) nuts
supporting the head unit carrier. Remove
the factory head unit and disconnect the
wiring..
1
MAZDA 929 1988-91
2
Cut and remove all mounting tabs on Radio
Housing #1 EXCEPT tabs "A". The
mounting tabs can be identified by the
stamped letter on the back of each tab. Skip
to the Installation Instructions for ALL
VEHICLES on Page #5.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(2) screws from the center console storage
compartment. Remove (1) screw under the
ashtray. Remove (1) screw from each side
of the center console panel and remove the
panel. Remove (1) screw exposed at the
base of the dash trim bezel. Pop out the a/c
vents and remove (2) screws exposed.
Remove the dash trim bezel.
1
MAZDA Miata 1990-99
2
"A"
"A"
"A"
"A"
"A"
"A"
Cut and remove all mounting tabs on Radio
Housing #2 EXCEPT tabs "E". The
mounting tabs can be identified by the
stamped letter on the back of each tab. Skip
to the Installation Instructions for ALL
VEHICLES on Page #5.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the ashtray and (2) screws exposed in the
ashtray cavity. Remove the radio trim bezel
and disconnect the wiring. Remove (4)
screws securing the factory head unit and
disconnect the wiring.
1
MAZDA MPV 1989-95
2
"E"
"E"