Nady Systems CX-222SW Car Speaker User Manual


  Open as PDF
of 7
 
Crossover Type ..............................................................Stereo 2 ways + Subwoofer
Crossover Range ............................................................Subwoofer: 50 - 250Hz, -24/10dB
Low/High : 250-6000Hz, -24/10dB
Filter Type (Slope) ..........................................................2nd order, 12dB/Octave
Inputs
Type ..............................................................................Balanced XLR and unbalanced 1/4"
Impedance ....................................................................100KΩ
Outputs
Type ..............................................................................Unbalanced 1/4"
Impedance ....................................................................220 Ω
Low Cut Filters................................................................30Hz/ - 3dB, 12dB/Octave
Frequency Response......................................................20Hz - 25KHz +/-1dB
Total Harmonic Distortion (THD) + Noise ....................< 0.05 %
S/N Ratio..........................................................................> 95 dB
Fuse..................................................................................0.5 A/ 250V, 5mm glass type
Dimensions......................................................................19’’ x 1.73’’ x 5.9’’ (483 X 44 X 150mm)
Weight..............................................................................4.4 lbs. (2.2 Kg)
9. FUSE COMPARTMENT:
Replace with only the same type fuse (0.5A/250V). If it blows continuously, do not use the unit
until it has been serviced by qualified personnel.
10. STEREO INPUT CONNECTORS:
Connect your L/R stereo input signal to either the balanced XLR or the unbalanced 1/4" phone jacks.
11. OUTPUT CONNECTORS:
Connect to your amplifiers via these unbalanced 1/4" phone jacks.
12. AC VOLTAGE SELECTOR SWITCH:
Before plugging in the power cord, check to see that the unit is set for the proper voltage for your
area:~115V (60Hz) or ~230V (50Hz).
13. POWER CONNECTOR
The IEC jack is used to connect the power cord to the AC Power Source.
(Caution: Do not remove the center grounding pin.)
Specifications and design subject to change without prior notice for improvement purposes
5
REAR PANEL
115V/60Hz
230V/50Hz
AC IN
FUSE 0.5A
HIGH LOWOUTPUT INPUT WOOFER
R CHANNEL
OUTPUT
L CHANNEL
HIGH LOW INPUT
XLR
BALANCE D
PIN
1
GND
PIN
2
HI
PIN
3
LO
SUB
Emeryville, CA, USA
Made in Taiwan
NADY SYSTEMS, Inc.
PHONE UNBAL
12
13 9 11
1110
10
11
CONTROLS AND CONNECTIONS
SPECIFICATIONS
 previous next