Nextar NC990C Car Stereo System User Manual


 
This is an anti-theft installation method.
The main unit wears a METAL MOUNTING SLEEVE.
Please connect the wiring, eg, the Power Supply, the Speakers and the Antenna
according to the requirements of this Instruction Manual, then install the metal
mounting sleeve into the car as per the diagram illustrated below.
METAL SUPPORT STRAP
METAL MOUNTING SLEEVE
DASHBOARD
FRONT PANEL
PLASTIC TRIM RING
UNIT CHASSIS
NOTE
Remove the two screws that
protect the CD player during
transportation before operating
the player.
To attach the removable faceplate, insert the
right side of the faceplate into the left of the
CD player chassis first. Then push the left side
of the faceplate into the chassis until.
Push this reset button with a
cuspidal object to renovate the
distorted program once the program
is distorted.
INSTALLATION METHOD
To properly fix the metal mounting
sleeve, bend the tabs of the sleeve
against the DASH BOARD with a
screwdriver.
To raise the anti-skip capability of the unit
please ensure the metal support strap is
connected firmly to the car chassis.
To remove the CD player from the Cage insert the
supplied keys into the Left and Right side slots of the
chassis then pull the chassis out of the cage as shown.
RESET BUTTON
NOTE:
When needing to insert MMC/SD card
into the MMC/SD card compartment or
to insert USB bar into the USB socket,
pull the plastic cover rightward away
from the player and then store it for safety.
When no needing to do MMC/SD or USB
operation, please make the plastic cover
match its right position in the front panel
and then push it from right to left till get to
the right position of the front panel.
To remove the front panel from the unit chassis,
press the REL key to release the front panel from
the unit chassis, then pull it up a little to take out
from the unit chassis.
E 10