Filter
Top Products
5) FADER CONTROL
A. Press the SEL button to select the fader mode until FAD appears on the display.
B. Rotate the VOL knob to increase or decrease the sound level of front / rear speaker.
(2) When pressed longer 2 seconds, it is activated as cyclical mode of following
functions for user’s selection.
-> BEEP (2nd/ALL/OFF) ->SEEK1/ 2 -> DSP(OFF/POP/ROCK/CLASSIC/FLAT)
->SUBW ON/OFF - > VOL LAST/VOL ADJ -> ESP 40/10 seconds mode.
After selecting the desired mode, rotate the VOL knob to select one setup item of
the desired mode.
BEEP 2ND, BEEP ALL, BEEP OFF MODE
The situation of beep sound is selected. The 3 mode is selected as also rotating the
VOL knob.
- Beep 2nd mode:
The beep is only generated when an allotted double key is pressed long (1 second).
- Beep all mode:
The beep is generated when every key is pressed.
- Beep off mode:
The beep sound is disabled when a key is pressed.
SEEK 1/SEEK 2 mode:( Only available during radio operation)
SEEK 1: Press and hold the >>| or |<< button to seek up or down for a station with a
strong signal. The seek stops when a station is reached .
SEEK 2: Press and hold the >>| or |<< button to seek up or down for a station with a
strong signal. The seek does not stop until the >>| or |<< button is released.
VOL LAST/VOL ADJ:
VOL LAST: The radio switches on at the actual volume it had when it was last
switched off.
VOL ADJ: Rotating the VOL knob you can pre-select a constant switch-on volume
after entering into this mode.
ESP 40 seconds/10 seconds:
In ESP mode, you can select 10 seconds or 40 seconds electronic shock protection
mode by rotating the VOL knob.
The default setting is at 40 seconds of anti-shock protection.
Using 10 seconds ESP will slightly improve the audio performance, while 40
seconds ESP will be effective when the vehicle is driven on a rough road.
2. COVER of MMC/SD and USB SOCKET
When needing to do MMC/SD or USB operation, open the cover, then insert the
MMC/SD card or USB bar into MMC/SD compartment or USB socket.
When no needing to do MMC/SD or USB operation, cover it with the cover after
pulling them out of the MMC/SD compartment or the USB socket.
E 3