Filter
Top Products
• Pream ps with Line Out jacks: connect one pair of Line
Out cables to your main am p to pow er your main L & R
speakers, and a second pair to the SW 10II OR SW 12
LINE LEVEL INPUT. If your pream p has only one pair of
Line O ut jacks, you can use a pair of "Y" connector
cords, available through your NHT dealer.
• Am ps and receivers w ith Pre-Out jacks: connect the
SW 10II OR SW 12 from the Pre-Out into the SW 10II OR
SW 12's Line Input.
2) Hi-Level
Use if:
Your receiver has no Pre O ut or Subw oofer/LFE O ut
jacks
To connect for a High-Level signal (Fig. 4), use two addi-
tional pairs of speaker cables, and connect as follow s:
• For am ps and receivers with separate A and B speak-
er outputs, connect one pair of speaker cables from your
receiver's Speaker A outputs to your main L & R speak-
ers, and a second pair from your receiver's Speaker B
outputs to the SW 10II OR SW 12's High-Level Input. Use
this method only if both A & B speaker outputs can oper-
ate simultaneously.
• For am ps and receivers w ith only one set of speaker
output terminals, simply feed the sam e signal, in parallel,
to both your main L & R speakers and the SW 10II OR
SW 12. Connect one pair of speaker cables from your
com ponent's speaker output terminals to the L & R
speakers, and a second pair from the sam e output ter-
minals to the SW 10II OR SW 12's High-Level input. The
SW 10II OR SW 12's input does not present a significant
load to the receiver, and will not com prom ise its output to
the L & R speakers. If you find that your receiver will not
accom m odate more than one cable per output terminal,
check w ith your N HT dealer for alternative m ethods of
connection.
With all signal connections com plete, it is now time to
apply AC pow er. Plug the pow er chord into the pow er
inlet in the back of the subw oofer, plug the other end into
into the w all outlet and sw itch the subw oofers pow er to
the ON position.
L
L
R
R
SPEAKER OUTPUTS
Pre Out
+
-
Reciever
Main Speakers
SW10 / SW12
Back of Subwoofer
Hi Level Input
Out R
InL
LFE
Low Pass
Filter
40Hz
+L--R+
Power
Mode
On
180
+3dB
-3dB
Auto
0
0
Phase
Boundary
180Hz
Min
Max
Volume
Line
Input
Fig. 3
Out R
InL
LFE
Low Pass
Filter
40Hz
+L--R+
Power
Mode
On
180
+3dB
-3dB
Auto
0
0
Phase
Boundary
180Hz
Min
Max
Volume
Line
Input
SW10 / SW12
Back of Subwoofer
LEFT RIGHT
+ +
- -
Reciever
Main Speakers
SPEAKER OUTPUT SPEAKER OUTPUT
ut R
InL
LFE
Line
Input
Hi Level Input
Fig. 4