Filter
Top Products
12. KEY- Used for various key control.
13. -,+ - Works as pitch bend and controls key
and pitch functions.
14. PITCH SLIDER- Controls the overall speed
of the music.
15. PITCH RANGE LED- Indicates current pitch
range of the pitch slider
16. EFFECT BUTTON- Used to determine
desired effect.
17. EFFECT HOLD- Used to set effects to an
alternate position
18. LOOP IN- Used to set stutter and loop in
points.
19. LOOP OUT- Used to set loop out points and
release the loop.
20. RELOOP/STUTTER- Used for repeated play
(stutter) from the loop in point, repeating a
previously set, and hot start.
21. RELAY- Used for setting Alternating play
start between attached units.
22. BEAT SYNC with MARCHING BAR GRAPH-
Tracks the beats and measure position of
music
23. CD Illumination Light (unit front) – lights
up the CD drawer and CD when open.
24. CD Drawer (Unit Front) – Place your CDs
you wish to play in here. This unit is
designed to play commercially available CD
and properly burned and finalized CDR.
Due to variances on the specification of
certain CD burners and CDs some discs
home made CDs may not play properly.
28 29 30 26 27
25
25. Power Switch- Turn on and turn off the
machine with this button. The unit should
always be shut down with this button first
before any external power is removed.
Typically it is recommended that the CD
player is powered on before amplifiers and
off after amplifiers to avoid an audio spike
to be sent through your equipment.
26. IEC Power Plug Connector - Plug your
supplied power cord in here.
27. Voltage Selector - Set this switch to the
voltage for your location.
28. RCA Audio Connectors - Connect your CD
player to your mixer from this line level
output.
29. Relay Connector- If you wish to use the
relay function plug in your 3.5mm stereo
control cables into here and then into your
other unit. The cable must be a stereo
style plug for the units to work properly
30. Remote Start Connector – Use this
connector to plug into your fader-start
compatible mixer or remote switch. This
function is always active.
a. To use fader-start, connect a 1/8” mono
minijack cable to a fader-start compatible
mixer. Every time you move the crossfader
on the mixer over to the side that the unit
is on, it will automatically start playing.
When you move the fader away from that
side, the unit will stop. Moving the fader
back to the unit side will start play again.
b. Foot switches can also be attached to this
jack for creative mixing techniques and can
be found in most music shops. Connector
plugs are often ¼” and an adapter to 1/8”
will be needed for connection. There are
also two types of footswitches that will
work with this connector. The first is a
typical, on/off pushbutton switch and are
generally used for switching channels on
guitar amps. The second switch is a
momentary footswitch and is usually used
for keyboard sustain pedals.