Filter
Top Products
13
En
SPEAKERS L/R terminals
12V TRIGGER IN/OUT jacks
Connects to the 12V trigger input and output jacks on
the other component to control the power amplifier.
This enables the amplifier to turn on or go into
standby state based on the standby status of the
connected component.
INPUT SELECT switch
This switch is located between the XLR IN and RCA
IN. Use this switch to select the input type for its
channel. When setting the switch to the left side, the
RCA audio input is selected. When setting the switch
to the right side, the XLR input is selected.
XLR IN jack
Connect preamplifier with XLR outputs for high-
quality sound.
AUTO STANDBY switch
You can use the Auto Standby (ASb) function. If the
power amplifier receives no signal for 3 hours, it will
automatically enter standby mode. Once the ASb
function has been activated, the power amplifier will
not automatically turn on even if it receives the signal.
To turn on the power amplifier, press ON/STANDBY
manually. You can also disable the function by setting
this switch to OFF side.
RCA IN L/R jacks
Connect preamplifier with single-ended outputs.
AC INLET
The supplied power cord is connected here. The other
end of the power cord should be connected to a
suitable wall outlet.
Rear Panel
Do not connect XLR and RCA at the same time. It
may damage the power amplifier.
See “Connections” for connection information
(➔ 15 to 19).