Filter
Top Products
© 2010 directed electronics—all rights reserved 3
INSTALLATION
The performance of the HCCA Component tweeters is directly proportional to the
quality of installation. Care taken during the installation process will be rewarded with
years of satisfying performance. If you are unsure about your installation capabilities,
please refer to your local Authorized Orion Dealer for technical assistance. Orion
dealers are trained professionals dedicated to extracting the maximum performance
out of your Orion system. If you decide to install this speaker system yourself, please
read the entire installation section before starting your installation.
FINDING SPEAKER MOUNTING LOCATIONS
Choosing the correct speaker locations will have the greatest effect on the sound
quality of the system. Different considerations are needed when choosing the
locations that best suit your needs. The locations must be large enough for the
speakers to fit. Care is needed to ensure that the location you have chosen will not
affect any of the mechanical or electrical operations of the vehicle. Determining the
best location for the speakers will depend on your cosmetic needs and your vehicle's
interior. If minimal intrusion in your vehicle is desired, factory speaker locations may
be the ticket for you. Placing the speaker in the factory location can often give very
desirable results.
DOOR MOUNTING
When checking for possible tweeter locations in the doors, check the operation of
the window and all assemblies. There is also a stabilizer stop bar in between the door
and the door jamb. This bar prevents the door from opening too far. Many shade tree
installers overlook this and check for clearance only when the door is fully open.
REAR DECK MOUNTING
In rear deck installations, check the operation of the trunk suspension springs or
tension bars. These tension bars move in the opening and closing of the trunk. You
cannot be too cautious during this part of the installation, In addition, do not locate
the tweeters too close to the back of the rear deck. Installing the far screws will only
be possible with the removal of the rear window.