Filter
Top Products
SPECIFICATIONS
Frequency 20hz-20kHz
Signal-to-Noise Ratio >85dB
Separation 65dB @ 1kHz
Crossover Slope 24dB/octave
Input Impedance 20,000 Ohms
Input Sensitivity variable, 300mV to 3V peak to peak
Output Level variable, 300mV to 5V peak to peak
Supply Voltage 9 to 16 VDC
INSTALLATION/MOUNTING
NOTE: As an option, before beginning, disconnect the
negative (-) terminal of the battery to prevent an electrical
short to ground. Reconnect the negative terminal only after
all connections have been made.
To prevent damage to the MaxxBass
®
Processor while driving, mount in a
secure place. Choosing the appropriate location will depend upon your
vehicle and the complexity of your system design. Typical mounting locations
include the trunk and passenger compartment (floor or under seat). Never
mount the MaxxBass
®
Processor in a location that would subject it to
immersion or exposure to water.
Once a location has been chosen, securely mount the MaxxBass
®
Processor
with the four mounting screws. Be Careful! Inspect the area underneath to
be sure you are not drilling into wires, brake or fuel lines, etc. that could be
damaged by the drill bits or screws.
6