Filter
Top Products
Model Orion P5.2 Orion P6.2
Nominal Impedance 4 ohms 4 ohms
Power
Continuous/Peak 100/150 100/150
Frequency Response 70Hz - 22kHz 60Hz - 22kHz
Sensitivity 87 dB 89 dB
Mounting Depth
w/grille 2.75” w/grille 3”
w/o grille 2.5” w/o grille 2.75”
Mounting Diameter 4
11
/16”5
5
/8”
INSTALLING THE CROSSOVER
Step 1: Find a location for the crossover away from any factory or after
market electrical wires. It is recommended to mount the passive
crossover close to the amplifier. In the event you decide to upgrade and bi-
amplify the system, mounting the passive crossover close to the amplifier
would simplify the installation upgrade.
Step 2: Remove top cover of crossover housing. Don’t lose it.
Step 3: Mark with a marking pen the two mounting holes.
Step 4: Remove crossover and pre-drill mounting holes using a 1/8” drill bit.
WARNING: Gas tanks, fuel lines, brake lines and electrical wires have a nasty
habit of hiding where you least expect. CHECK BEFORE YOU DRILL!
Step 5: Mount the crossover using the supplied #8 screws.
Step 6: Connect the wires. Make sure the speaker wires for the midrange
go to the woofer output and the tweeter to the tweeter output. Be sure to
observe the correct polarity. Changing the polarity of the tweeter may be
necessary for optimum sound quality.
Step 7: Re-install the crossover cover.
6
+
-
+
-
+
-
TTWWEEEETTEERR
WWOOOOFFEERR
TTOOAAMMPPLLIIFFIIEERR
SPECIFICATIONS