Filter
Top Products
FLUSH MOUNTING INTO REMOVED PANELS (diagram A)
Step 1:
. Determine the tweeter mounting location, then route the wires from
the crossover to the tweeter location.
Step 2: Mark the center point of the tweeter location.
Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using
a standard 2-1/8" hole saw.
Step 4: If not using a hole saw, use either the cardboard packaging for the
tweeters or the surface mount trim ring as a template to mark the
proper size hole. Cut out the hole.
Step 5: With the tweeter assembled, route the wires through the hole and
the pressure ring and slip the pressure ring over the tweeter
assembly.
Step 6: Align the tweeter so the logo faces the desired direction then
push the pressure ring on to the rear of the tweeter assembly until
the tweeter is snugly mounted to the panel.
Step 7: Connect the speaker wires observing the correct polarity and
re-assemble the panel.
FLUSH MOUNTING INTO MOUNTED PANELS (diagram B)
Step 1: Determine the tweeter mounting location, then route the wires from the
crossover to the tweeter location.
Step 2: Mark the center point of the tweeter location.
Step 3: If using a hole saw, first drill a pilot hole, then cut out the hole using a
standard 2-1/8" hole saw.
Step 4: If not using a hole saw, use either the cardboard packaging for the
tweeters or the surface mount trim ring as a template to mark the proper
size hole. Cut out the hole.
Step 5: Remove the tweeter from the flush mount housing and insert the proper
length machine bolt through the center hole of the housing and connect
to the spring steel X-bracket. (See Figure 3.)
Step 6: Connect the speaker wires observing the correct polarity.
Step 7: Press the X-bracket portion of the assembly through the hole until its legs
spring open.
Step 8: Screw the bolt in until the tweeter housing is firmly mounted to the
panel. (Make sure the arrow at the rear of the tweeter housing is pointing
in the desired direction.)
Step 9: Insert the tweeter into the housing and attach trim ring.
5
DRW-12
FLUSH MOUNT
TWEETER
ASSEMBLY
PRESSURE
RING
WIRING HARNESS
TWEETER WIRE
DRW-68
WIRING HARNESS
FLUSH MOUNT
TRIM RING
TWEETER
HEX HEAD BOLT
FLUSH MOUNT
HOUSING
PANEL X-BRACKET
TWEETER WIRE
A
B