Filter
Top Products
System 3 uses a 4-channel amplifier to drive an entire system. The front channels are configured high-pass operation for satellites. The rear channels
are configured low-pass for two dual voice coil subwoofers.
• Lowest recommended impedance for front channels is 2Ω per channel
• Front channels configured for high-pass operation
• Front channels configured for stereo operation
• Lowest recommended for rear channels is 2Ω per channel
• Rear channels configured for low-pass operation
• Rear channels configured for summed stereo operation
• Amplifier can be configured either for 2-channel or four-channel inputs
Note: when the amplifier is configured for 4-channel input the fader on the source unit can control the output level between the subwoofer and
satellites.
SYSTEM PLANNING SYSTEM 3
page 13