Filter
Top Products
Pacic Accessory Corporation - Santa Ana, CA 92705
866-931-8021 • www.pac-audio.com
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the TATO be held liable for consequential damages sustained in
connection with the TATO. The manufacture and it’s distributors will not, nor will they authorize any representative or any other individual to assume
obligation or liability in relation to the TATO other than its replacement.
06-29-10
Warranty:
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction. This warranty applies only to the original purchaser of this prod-
uct from an authorized Pacic Accessory Corporation dealer. This warranty covers any supplied or manufactured parts of this product that, upon inspec-
tion by Pacic Accessory Corporation authorized personnel, is found to have failed in normal use due to defects in material or workmanship. This war-
ranty does not apply to installation expenses. Attempting to service or modify this unit, operating this unit under conditions other than the recommended
voltage will render this WARRANTY VOID. Unless otherwise prescribed by law, Pacic Accessory Corporation shall not be liable for any personal injury,
property damage and or any incidental or consequential damages of any kind (including water damage) resulting from malfunctions, defects, misuse,
improper installation or alteration of this product.
All parts of this Pacic Accessory Corporation product are guaranteed for a period of 1 year as follows: Within the rst 12 months from date of pur-
chase, subject to the conditions above, Pacic Accessory Corporation will repair or replace the product at their discretion, if it is defective in material or
workmanship providing it is returned to an Authorized Pacic Accessory Corporation Dealer, with PROOF OF PURCHASE from an authorized Pacic
Accessory Corporation dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation. Exposure to direct sunlight or extreme heat may cause damage
or malfunction.
FCC Class B Radio Frequency
Interference Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help
Notice : The changes or modications not expressly approved by the party responsible for compliance could void the user authority to operate the equip-
ment.
Adjusting Volume Output:
When initially connecting the TATO to the vehicle the
max output might not meet that of the factory radio.
If the volume is low you can adjust the output using
the dip switches on the side of the module. It is rec-
ommended to use a 4 volt RMS capable aftermarket
radio. When adjusting the gain output it is recom-
mended to start with the plus 7dB setting and working
your way down.
Note: It may take up to 10 seconds before the gain
adjustment is heard.
The dB gain adjustments are as follows:
Set all other dip switches 4-8 to OFF (up) position