Filter
Top Products
Accessories
Use numbers indicated in parentheses when asking for replacement parts.
(Product numbers correct as of January 2006. These may be subject to change.)
∑
2
Stereo headphones (RP-HT40)
∑
1
Headrest Mounting Bracket (RXQ1405A)
∑
1
Monitor holder (RGQ0442-K)
How to connect the headphones
How to install the Headrest Mounting Bracket and the Portable DVD Player.
You can enjoy video in the back seat attaching the unit to the back of the front seat.
1
Attaching the Headrest Mounting Bracket to the front seat.
2 Attaching the monitor holder.
3 Attaching the unit to the bracket.
While holding the unit with both hands, line it up just below the protruding
sections on the bracket as shown in the illustration on the left.
Press the unit down about 4 to 5 mm until you hear a “click” as it locks into place
.
At
this point, line the protruding sections up with the holes on the bottom of the
player.
Folding method
Input plug
(
‡
3.5mm (1/8
q
) L-shaped
stereo mini plug)
Portable DVD/CD Player
(Illustrations in these operating
instructions are of DVD-LS91.)
Headphone
Jack
If the housings do not fit,
move up or down.
1 Fold the monitor down
towards the front of the unit
and attach the monitor
holder
2 Rotate the monitor
backwards so the screen is
facing out, and lock into
place with the monitor
holder.
Side view
Headrest
Mounting
Bracket
2 Close the buckle and adjust the belt until it fits tightly around the headrest.
1 Adjust the headrest so there is an open space of about 3 cm.
Monitor holder
(included)
Check that the monitor is locked into position.
Detaching the monitor
Press the monitor holder as
shown to detach it.
After use, detach the
monitor holder from
the unit. You can
store it in the bracket.
click!
When correctly
attached,
you will hear a
locking sound.
Line up the protruding
sections here.
Refer to the following illustration for lining up the protruding sections
on the bracket with the holes on the back of the unit.
Use the monitor in the open
position as shown in the
illustration to the right to
prevent abnormal audio or
damage resulting from
vibrations in the car.
The angle of the monitor
can be adjusted up to
about 30 degrees.
Diagram of attached bracket
The angle of the monitor may shift
while driving due to vibration, etc.
1
Press the release buttons (left and right)
in towards the center of the bracket.
2Lift the unit up to release it.
Press the release buttons only when
detaching the unit.
Releasing the unit from the bracket
≥
Depending on the type of
headrest, you may not be
able to attach the bracket.
23cm
or less