Filter
Top Products
9
1
E
N
G
L
I
S
H
CQ-C5403U/C5303U
8
Preparation
Warning
¡Keep a battery away from children to avoid the risk of
accidents. If an infant ingests a battery, please seek
immediate medical attention.
Caution
¡ Remove and dispose of an old battery immediately.
¡ Do not disassemble, heat or short a battery. Do not
throw a battery into a fire or water.
¡ Follow local regulations when disposing of a battery.
¡Improper use of a battery may cause overheating, an
explosion or ignition, resulting in injury or a fire.
Note:
¡Battery Information:
Battery Type: Panasonic lithium battery (CR2025)
(Included in the remote control)
Battery Life: Approximately 6 months under normal use
(at room temperature)
Remote Control Unit
Preparation Before Initial Use
Pull the insulation film out from the
backside of remote control gently.
Battery Replacement
The demonstration message appears for initial use.
q Set your car’s ignition switch to the ACC or ON position.
The demonstration screen appears.
wPress [SRC/PWR] to turn on the power.
e Press and hold [VOLUME] (PUSH SEL) for more
than 2 seconds to open the menu.
r Press [VOLUME] (PUSH SEL) to select the
Demonstration setting. (“DEMO” is displayed.)
t Turn [VOLUME] counterclockwise. (Press [0] (
{
) on
the remote control unit.)
Note:
¡ To return to the regular mode, press [D] (DISP).
¡ Refer to the section on “Function Settings”.
(a Page 26)
Main Unit
The 12-hour system is used for the clock.
qPress [SRC/PWR] to turn on the power.
wPress [D] (DISP/CLOCK).
Clock display
ePress and hold [D] (DISP/CLOCK) for more than 2
seconds.
Hour blinks
rAdjust the hour.
[[]: put forward hour.
[]]: put back hour.
Hour entered
tPress [D] (DISP/CLOCK).
Minute blinks
yAdjust the minute.
[[]: put forward minute.
[]]: put back minute.
Minute entered
uPress [D] (DISP/CLOCK).
Completed
Note:
¡“ADJUST” is displayed before adjusting the clock.
¡Press and hold [[] or []] to change numbers rapidly.
Cancellation of Demonstration Clock Setting
[SRC/PWR] (Power)
[D] (DISP/CLOCK)
[]][[]
(Hour/minute adjustment)
q
w
q Remove the battery holder with the
remote control unit placed on a flat
surface.
q Stick your thumbnail into the
groove, and push the holder in the
direction of the arrow, and at the
same time.
w Pull it out in the direction of the
arrow using a tough pointed object.
2
3
wPut a battery in the case with (+) side
facing up.
ePut the case back.
Tough pointed
object
Back side
[VOLUME]
(PUSH SEL: select)