Filter
Top Products
10
With this type of set-up, the original connectors of
your vehicle’s audio system need not be removed.
On some vehicles, there is no ignition +12V on the
vehicle’s connectors. You must therefore connect
the orange power supply wire to the fuse box or
another ignition power source.
2. Join the vehicle’s audio and power supply cables to the
female connectors of the Parrot MKi9000.
3. On the installation cable, connect the free yellow wire to
one of the audio system’s corresponding mute-in jacks if
available (mute in 1, mute in 2 or mute in 3).
Car stereo with line-in jacks
• Use this type of connection by wiring a line-out jack
(brown & white wire or red & black wire) to your car
stereo’s line-in jack.
• Using the two pairs of line-out jacks will enable you to
take advantage of the streaming audio function in stereo
over your vehicle’s speakers.
• On the installation cable, connect the free yellow wire to
one of the audio system’s corresponding mute-in jacks if
available (mute in 1, mute in 2 or mute in 3).
Car stereo without ISO connectors
To simplify the wiring procedure, you will need to purchase an
ISO adapter cable. Refer to the range of ISO adapters on our
website: www.parrot.com.
Installing the kit’s power cable
• Refer to your car stereo’s wiring diagram.
• The red wire of the kit’s cable must correspond to the
constant +12V supply, the orange wire to the ignition +12V
and the black wire to ground.
• Check that the orange wire is not connected to the constant
+12V supply, as you could run down the vehicle’s battery,
preventing your hands-free kit from operating correctly.
• On some vehicles, the red and orange power supply
wires may need to be reversed. This can easily be done
by reversing the two fuse holders on the Parrot MKi9000
installation cable.
Installing the audio connectors
• Connect the music cable to the electronic box and
place the USB / iPod ® / Jack connectors into the glove
box, the central console or the parcel tray depending on the
configuration of your dashboard.
• To protect the connectors from dust, use the provided
protection cap.