![](http://pdfasset.owneriq.net/6/05/60589c87-14d7-44f8-bdfd-8fb316c6ca90/60589c87-14d7-44f8-bdfd-8fb316c6ca90-bg1.png)
Monarch
®
1103
®
-1110
®
Labelers
Operating Instructions
TC1000OI Rev. DF 1/08 ©2007 Paxar Americas, Inc. a subsidiary of
Avery Dennison Corp. All rights reserved.
LOADING LABELS & SETTING PRINT BANDS
LOADING LABELS
1
If labeler has no label guide: Snap
label roll between hubs. Tear off
and discard first twelve labels and
backing paper.
2
Squeeze and hold
operating lever half way,
and feed label strip under brake
wheels.
3
Continue feeding label
strip until about twelve
labels come out here. Release
operating lever.
4
a. Feed label strip up under
plate until two labels come
out here.
5
Grasp label strip and pull
briskly toward operating
lever,
6
Tear backing paper as
shown.
7
Completely squeeze operating
lever, exposing feedwheel.
Insert backing paper into slot. When
paper bows up, maintain finger
pressure and release operating
lever.
8
Squeeze operating lever
several times until backing
paper exits labeler. If backing
paper does not become taut and
exit at rear, remove backing
paper from slot and repeat steps
6 and 7.
SETTING PRINT BANDS
1
Pull knob until indicators point to
desired band.
2
Turn knob until indicators point
to desired character or blank.
3
Set all bands and push
knob in all the way.
n
Make sure the character you
select is not a print character
(UPSIDE DOWN). You
should be able to read the
character correctly through
the band window.
INKING
1
Turn latch to release ink roll
door and carefully pull it
completely out of labeler.
2
Fold a piece of scrap backing
paper.
3
Insert folded backing paper
between ink roll and
carrier. Pull to snap old ink roll
free.
4
Cut off end of new ink roll
pouch. Using pouch to protect
fingers, slide carrier into pouch and
snap new ink roll into carrier (one side
at a time).
5
Insert ink roll into ink door
opening. Tilt ink door
and press in...
6
Latch ink roll door securely.
Hang for
easy reference.
INKING
Brake
Wheel
Loop
Plate
b. Squeeze operating
lever halfway and rewind
label roll until loop is
removed.
separating
labels
from
backing
paper.
Discard
separated
labels.
Straight tear
between I-cuts
Backing paper
without labels
Slot
Feedwheel
Indicators
Ink Roll Door
Latch
Lip
to place
hinge tab
under lip.
Operating
Lever
Guide Slot
Label Guide
â
If labeler has label guide: Snap
label roll between hubs. Tear off
and discard first twelve labels and
backing paper. Then, insert label
strip into guide slot as shown.