Filter
Top Products
17
T O p p a n e l
4
5
6
7
8
9
10
11
Switches the XLR (5) PIN 1 from direct contact with ground in the event that hum occurs.
The primary input is switchable between line-level and mic-level input. The line-level input is of the medium impedance
balanced type, and when switched to mic-level(6) it is of a typical low-Z mic input impedance. Jack (5) is a combo female
XLR and 1/4" TRS connector.
Switches the sensitivity of the primary input (5) from line-level to mic-level sensitivity. Pushed in, the sensitivity is set for
line-level input signals. When the switch is not pushed in, the sensitivity is increased by 30 dB so it is suitable for mic-level
signals.
Illuminates green when PAD switch (6) is in line-level mode, and yellow when the PAD is in mic-level mode.
Controls the gain (level) of the Primary Input (5) of the powered speaker system. It is used to directly set the system output
level for the input signal.
Illuminates GREEN when the electronics receive power (when the Power switch (2) is On). Illuminates RED when amplifier
clipping is occurring or the unit has tripped the thermal protection system.
Link Out is a 1/4" post-level send intended for the use of linking multiple PV
®
15 PM’s in a line. In that case, the Link Out
would connect to the 1/4" connections of the MIC/LINE (5) input of the next PV
®
15 PM in the line of PV speakers. All of the
PV
®
15 PM’s in the line should have their respective PADs (6) engaged and Level control (7) set to mid-position. The first PV
can use it's level control to set the volume for all of the other PV speakers in the line.
Direct In is a 1/4" line input that can be used to drive the PV
®
15 PM directly from a mixer, or other line level source. This
input jack has switching contacts that disconnects the PV
®
15 PM pre-amp, therefore the level control on the PV
®
15 PM does
not affect the volume of the speaker.
4 5 6 7 8 9 10 11