Pelco C544M Car Satellite Radio System User Manual


 
INTRODUCTION CM9760-SAT i
Required Software:
CC1 Interface:
CM9760-MGR (System MGR) @ ver 7.80.003 or greater (external PC)
CM9760.EXE @ ver 7.80.003 or greater (9760 HD)
CM9760-KBD @ ver 7.80 or greater
(For software upgrade information, contact Technical Support at 1-800-289-9100.)
(Comm Parameters)
Equipment # 31
Baud Rate 9600
Parity ODD
The CM9760-SAT is a sequential video switcher
for use as a Satellite Control System of the
CM9760 system. Below are shown the front and
rear views, the mounting geometry and, for ref-
erence, the pinout designations for all connec-
tors on the unit. The four, 12-pin and one, 6-pin
wiring plugs (shown in Figure 2) are supplied
with the unit. Especially note the COM 2 con-
nector designations. Required software version
levels and other Comm parameters are given
in the information box to the left.
Observe the precaution outlined
in the NOTE below.
Orient unit as required.
Mount as deemed appropriate
to your installation.
R E A R
NOTE:
Factory default, video input termina-
tion is 75-ohm, non-looping. If you want the
loop-thru option active for any video input, the
top cover of the unit must be removed to make
the change
(see Section 1,
3.2.1, Looping
Video Inputs
).
You may want to do this before
rack-mounting the unit.
FIGURE 1
CM9760-SAT Front View, Including Mounting Geometry
FIGURE 2
CM9760-SAT Rear View
F R O N T