Filter
Top Products
Figure 1. DA104DT 120 VAC Input Diagram
INSTALLATION
Plug power cord into a 120 VAC, 60 Hz or 230 VAC, 50 Hz source depending on model ordered.
Connect the input to a video camera with 75 ohm coax cable. Each output is capable of
supplying video to more than one monitor. If more than one monitor is used, only the last monitor
in line must be terminated. The other monitors must be set for high impedance input. An output
used with a single monitor will require that monitor to be terminated in 75 ohm impedance.
Figure 2. DA104DT 230 VAC Input Diagram