Pelco ea2010 Car Amplifier User Manual


 
®
EA2010 Post Equalizing
Video Amplifier
Installation/Operation
Manual C630M Rev A (8/90)
1.0 WARNINGS
Prior to installation and use of this product, the follow-
ing WARNINGS should be observed.
1. Installation and servicing should only be done by
Qualified Service Personnel and conform to all
Local codes.
2. Unless the unit is specifically marked as a NEMA
Type 3, 3R, 3S, 4, 4X, 6, or 6P enclosure, it is de-
signed for indoor use only and it must not be in-
stalled where exposed to rain and moisture.
4. Only use replacement parts recommended by
Pelco.
5. After replacement/repair of this unit’s electrical
components, conduct a resistance measurement
between line and exposed parts to verify the ex-
posed parts have not been connected to line cir-
cuitry.
2.0 SCOPE
The information contained within this manual covers
the EA2010 Post Equalizing Video Amplifier.
3.0 DESCRIPTION
The Pelco EA2010 provides a low cost, highly effec-
tive means of maintaining CCTV picture quality in runs
of up to 3000 feet (914.4 m) of RG59 cable.
Through panel controls provided for adjustable overall
amplifier flat gain of 1 to +8 dB plus adjustable high
frequency boost of 0 dB to greater than 18 dB at 12
MHz, mainlining full video amplitude, contrast and
detail.
The EA2010 features all solid-state circuitry and is sup-
plied with a U.L. Listed wall transformer. Applications
should be for POST-EQUALIZATION only (located
near the monitoring equipment); use as a pre-equalizer
is discouraged.
Pelco • 300 W. Pontiac Way, Clovis, CA 93612-5699 • USA • (800) 289-9100 or (1-559) 292-1981
FAX (800) 289-9150 or (1-559) 292-3827 • DataFAX (800) 289-9108 or (1-559) 292-0435
International customers call (1-559) 292-1981 or FAX (1-559) 348-1120