Philips BT3500 Car Speaker User Manual


 
9EN
6 Product
information
Note
Product information is subject to change without prior
notice.
Specications
Amplier
Rated Output Power 2 X 5 W RMS
Signal to Noise Ratio > 62 dBA
AUX Input 600 mV
Bluetooth
Bluetooth version V3.0
Supportedproles HFP v1.6, A2DP v2.1,
AVRCP v1.0
Range 10 m (Free space)
General information
Power Supply (through
USB socket)
5 V 1 A
Built-in Battery Li-polymer battery
(3.7 V, 2200 mAh)
Dimensions - Main Unit
(W x H x D) 201 x 101 x 35 mm
Weight - Main Unit 0.5 kg
7 Troubleshooting
Warning
Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
General
No power
• Recharge your speaker.
No sound
Adjust volume on the speaker or the
Bluetooth-connected device.
Make sure that your Bluetooth device is
within the effective operational range.
No response from the speaker
Restart the speaker.
About Bluetooth device
The audio quality is poor after connection
with a Bluetooth-enabled device.
The Bluetooth reception is poor. Move the
device closer to this product or remove
any obstacle between them.
Cannot connect with the device.
The Bluetooth function of the device is not
enabled. Refer to the user manual of the
device for how to enable the function.