Filter
Top Products
English
Install the car audio
These instructions are for a typical installation.
However, if your car has different requirements,
make the corresponding adjustment. If you have
any questions regarding installation kits, consult
your Philips car audio dealer.
Connect wires
1
1 Check the car’s wiring carefully, then
connect them to the supplied ISO wires.
a
Connector Connect to
1 Yellow wire The +12V car battery which
is live at all times .
2 Blue wire The electric antenna control
lead or power supply lead of
the antenna booster
If there is no electric antenna
or antenna booster, or it is
manually operated telescopic
antenna, it is not necessary
to connect this lead.
3 Black wire A metal surface of the car
First connect the black
ground (earth) lead, then
connect the yellow and red
power supply leads.
4 Red wire The +12V power terminal
which is live in the
accessory (ACC) position of
the ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be sure
to connect the black ground
(earth) lead to a metal
surface of the car fi rst.
5 Green and
green/black
wires
Left speaker (Rear)
6 White and
white/black
wires
Left speaker (Front)
7 Gray and
gray/black
wires
Right speaker (Front)
8 Purple and
purple/black
wires
Right speaker (Rear)
2 Connect the other end of the supplied
standard connector to the car audio
system.
b
Connector/
Obeject
Connect to/with
1 Pink wire Extension wire
2 2.5m extension
wire(Not
included)
Parking brake (-)
3 Brake switch
4 Ground
5 ISO wires Connected in step 1
above.
6 Grey wire Rear line out Left/
Right
7 Black wire Front line out Left/
Right
8 Blue cable Subwoofer
9 Red cable Aux Right
10 White cable Aux Left
11 Yellow cable Video in
12 Yellow cable Camera in
13 Yellow cable Video out 1
14 Yellow cable Video out 2
15 Purple wire Reverse camera (B+)
16 Gearbox switch
17 Reverse gear
signal
Back lamp lead +
Mount in the dashboard
2
1 If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
2 Ensure that car dashboard opening is within
these measurements:
a
3 Slide the unit into the dashboard until a
click sound is heard.
b
4 Attach the trim plate.
c
5 Reconnect the negative terminal of the car
battery.