Filter
Top Products
Amplier Owner’s Manual
www.phoenixgold.com
SENS
Used to reach maximum amplier power with a wide variety of headunits.
X-OVER CONFIG
FLAT: Crossovers are turned o
HPF: High pass crossover is on
LPF: Low pass crossover is on
LP/BP: Low and high pass crossovers are both on, creating a Bandpass (BP) lter for
midbass/midrange drivers. If running a subwoofer the HPF now becomes a
subsonic lter, to turn o the HPF/subsonic lter set it to 20Hz.
Note: The front HP and rear LP crossovers extend to 4kHz, so its possible to run a
component speaker system fully active. The tweeters would be powered by the
front channels and the midbasses by the rear channels. Be sure to check with your
speaker’s manufacture for the correct tweeter and midbass crossover points to avoid
speaker damage.
+12V
This must be connected to the fused positive terminal (+12V) of the car’s
battery. The fuse must be located within 18 inches of the battery.
REMOTE
This must be connected to switched +12V, usually a trigger wire coming
from the head unit or ignition.
GROUND
This must be connected to the negative terminal of the car’s battery or
bolted to a clean, unpainted part of the chassis of the vehicle.
REMOTE MONITORING DISPLAY (RMD)
Connect optional RMD Voltage Display to this port.
SPEAKER OUTPUTS
Used to connect the amplier to speakers. Ti2 1000.4’s minimum
impedance is 4 ohms bridged or 2 ohms stereo. Use the Left + and
Right - to bridge the channels.
CLIP INDICATORS (located on top of the amplifier)
Lights when the amplier reaches near maximum output. Under heavy
use the clip indicators should be ashing during the peaks of the
music. The clip indicator should not stay lit for long periods of time (more
than 1 or 2 seconds), if this is the case you need to reduce system volume
or the SENS of the amplier.
Ti2 1000.4
4 Channel Power Amplifier
FRONT AND REAR INPUTS
Connect preamp signal cables from headunit to these inputs. The front
and rear inputs must be used, if only the front input is used then the rear
speaker outputs will have no output signal.
HPF/LPF CROSSOVER FREQUENCY
Controls the crossover points for the speaker outputs.