Filter
Top Products
14
English
Español
Deutsch
Français
Italiano
Nederlands
DIN Front/Rear-mount
This unit can be properly installed
either from “Front” (conventional DIN
Front-mount) or “Rear” (DIN Rear-
mount installation, utilizing threaded
screw holes at the sides of unit chas-
sis). For details, refer to the following
illustrated installation methods.
Before installing the unit
• Remove the frame and the hold-
er. (Fig. 11)
Pull out to remove the frame and then
loosen the screws (2 × 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
Fig. 11
DIN Front-mount
Installation with the rubber bush
1. Decide the position of the side
brackets. (Fig. 12)
When installing in a shallow space,
change the position of side brackets. In
this case, stick conceal tape on parts
that protrude from the dashboard.
Fig. 12
Conceal tape
Side bracket
Flush surface screw (5 × 6 mm)
Holder
Frame
Screw (2 × 3 mm)