Filter
Top Products
2 Press MULTI-CONTROL to turn ASL on.
ASL level (e.g., Mid-Low) appears in the dis-
play.
# To turn ASL off, press MULTI-CONTROL
again.
3 Push MULTI-CONTROL up or down to
select the desired ASL level.
Each pushing MULTI-CONTROL up or down
selects ASL level in the following order:
Low (low)Mid-Low (mid-low)Mid (mid)
Mid-High (mid-high)High (high)
Note
When the ASL mode is turned on and exited, ASL
appears on the display of each source.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
! Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2 Use MULTI-CONTROL to select SLA.
The function name tag SLA is highlighted.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
3 Push MULTI-CONTROL up or down to
adjust the source volume.
Each pushing MULTI-CONTROL up or down
increases or decreases the source volume.
+4 4 is displayed as the source volume is
increased or decreased.
Notes
! The AM tuner volume level can also be ad-
justed with source level adjustments.
! The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
! External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
Auto TA and EQ (auto-time
alignment and auto-
equalizing)
The auto-time alignment is automatically ad-
justed for the distance between each speaker
and the listening position.
The auto-equalizer automatically measures
the car interior acoustic characteristics, and
then creates the auto-equalizer curve based
on that information.
WARNING
To prevent accidents, never carry out auto TA and
EQ while driving. When this function measures
the car interior acoustic characteristics to create
an auto-equalizer curve, a loud measurement
tone (noise) may be outputted from the speakers.
CAUTION
! Carrying out auto TA and EQ under the follow-
ing conditions may damage the speakers. Be
sure to check the conditions thoroughly be-
fore carrying out auto TA and EQ.
When speakers are incorrectly connected.
(e.g., When a rear speaker is connected to
a subwoofer output.)
Audio Adjustments
En
55
English
Section
11